Electrolux Washer No Water Error Message

Check the little filter screens where the fill hoses connect to the back of the washer.

Electrolux washer no water error message.

Tap closed or water pressure too low. You ll need to pull the washer forward and turn the water off to the washer. Turn the water on to make sure you have good water pressure from both hot and cold water lines. Water fill solenoid valve is faulty.

Tap closed or water pressure too low. If everything checks good you just need to replace your electronic water valve because it has failed and isn t letting any water into the washer. Leaks from water circuit on pressure switch. Washer dryer displays error message e30 c3 or emits 3 beeps.

The error is caused by water at the bottom or inside the machine. If the hoses are good and you haven t found anything slowing down the flow of the water your electronic inlet water valve is just faulty on the back of your washer and will need to be replaced because it s just not allowing water flow into the washer correctly. Drain tube improperly dositioned. Leaks from water circuit on pressure switch.

Drain tube improperly dositioned. Disconnect the fill hoses from the back of the washer and put them in a 5 gallon bucket.